所有类别
Polyamide (nylon) wire
Polyamide (nylon) wirePolyamide monofilament is used to be called nylon filament. The production method is the same as that of polyethylene wire and polypropylen…
Company news 424 2022-10-24
PVC wire
PVC wire(1) The raw material for PVC filament extrusion molding is SG5 resin in suspension PVC as the main raw material, and a certain proportion of stabilizer, …
Company news 439 2022-10-22
Polypropylene filament
Polypropylene filamentb. The raw materials in the hopper are "bridged" and the feeding is discontinuous.c. The fit clearance between the barrel and the…
Company news 434 2022-10-21
Extrusion molding of plastic wire
Extrusion molding of plastic wire① The single screw extruder with the screw diameter of 45mm or 65mm is generally selected for the extrusion of PE monofilament.…
Company news 432 2022-10-20
Analysis of quality problems in profile extrusion
Analysis of quality problems in profile extrusionThe temperature is too high, the product molding is difficult, and the raw materials are easy to decompose. ④ D…
Company news 416 2022-10-19
Extrusion molding of plastic profiles
Extrusion molding of plastic profilesPlastic profile refers to the thin-walled or solid structure of plastic products whose sectional shape is different from tha…
Company news 413 2022-10-18
Performance index of PP diaphragm
Performance index of PP diaphragmNote: The change rate of longitudinal dimension is not considered for the sheet with thickness less than 0.5mm.⑤ The filter scr…
Company news 429 2022-10-17
Polyethylene sheet (sheet) extrusion molding
Polyethylene sheet (sheet) extrusion molding(1) Raw materials for extrusion forming of polyethylene sheet (sheet) shall be special resin for sheet forming. For e…
Company news 452 2022-10-14
Plastic Film Extrusion Molding
Chapter 6 Plastic Film Extrusion Molding③ Pay attention to the temperature control of the cylinder when the resin is plasticized. As PS material is a thermosens…
Company news 426 2022-10-13
Key points of process operation
Key points of process operation① The plasticizing heating temperature of raw materials in the barrel shall be gradually increased from the feeding section to th…
Company news 460 2022-10-12
Plastic film extrusion
Plastic film extrusionThe clearance and air pressure knife edge clearance are about 3mm, and the blowing air pressure is about 0.5MPa.E Process parameters of lon…
Company news 427 2022-10-11
Production process sequence of biaxially oriented polypropylene film
Production process sequence of biaxially oriented polypropylene filmAs shown in Fig. 6-35. The product forming process is as follows.Polypropylene resin and auxi…
Company news 412 2022-10-10